Guide · Cafés and Businesses · 4 min read · Updated 17 November 2026
Building a Café Counter and Back Bar: A UK Guide
Short answer
A small café counter up to three metres starts from about £4,500, and a full front counter with back bar, sinks, drainage and electrics from £9,000. Plan the workflow first, then services: a mains water feed, drainage, dedicated power for the espresso machine and a separate handwash basin. New food businesses must register with their local authority at least 28 days before trading.
Design around the workflow
A good café counter is laid out around the order of service: customer orders and pays, the barista grinds, brews and steams, the drink is handed over and cups go back to wash. Each step should flow in one direction without staff crossing each other. The till usually sits at the customer end, the grinder and espresso machine in the middle, and the hand-off point at the far end, with the dishwasher or sink close to where used cups come back.
Staff need room behind the counter. Around a metre between front counter and back bar lets two baristas pass safely carrying hot drinks. Less than that and service slows down at busy times, which costs money every day the café trades.
Structure and materials
The counter must carry heavy equipment and take daily knocks. Frames are usually built from treated timber or steel, with a strong top to carry the espresso machine. The front, which customers see, can be clad in laminate, timber, tiles, fluted panels or metal, while the working side uses hard-wearing, easy-clean surfaces. Tops are commonly stainless steel, quartz, compact laminate or sealed stone.
Hygiene drives material choice. Surfaces in food preparation areas should be smooth, durable and easy to clean, so open-grain timber is usually kept to the customer-facing parts. Plinths and the bottom edges of cladding should resist mopping and occasional spills.
| Element | Common materials | Why |
|---|---|---|
| Working top | Stainless steel, quartz, compact laminate | Heat resistant, wipe-clean, durable |
| Customer front | Laminate, timber, tiles, fluted panels | Branding and appearance |
| Frame | Treated timber or steel | Carries heavy machines and fridges |
| Plinth | Stainless or sealed laminate | Resists mopping and spills |
| Back bar shelves | Laminate, timber, metal | Display and storage |
Services: water, drainage and power
A commercial espresso machine usually needs a mains water feed with a filter, a drain connection for the drip tray and a dedicated electrical supply sized to the machine. Many two- and three-group machines cannot run from a standard plug and need a hard-wired or dedicated socket supply installed by an electrician to BS 7671. Grinders, under-counter fridges, a dishwasher, a till and display lighting all add to the electrical load, so a load check at the design stage avoids nuisance tripping later.
Water feeds must meet the Water Supply (Water Fittings) Regulations 1999, which require suitable backflow protection on appliances connected to the mains. Service grommets in the counter top and access panels behind fridges and machines make cleaning and servicing easier.
- Dedicated supply for the espresso machine
- Mains water feed with filtration and backflow protection
- Drainage for the drip tray, sinks and dishwasher
- Ventilation gaps for under-counter fridges
- Service grommets and removable access panels
- Separate handwash basin with hot and cold water
Food business rules to plan for
Anyone starting a food business in the UK must register with their local authority at least 28 days before they begin trading, and registration is free. Environmental health officers expect food preparation areas to have adequate facilities for washing hands, which in practice means a dedicated handwash basin with hot and cold running water, separate from sinks used for washing equipment or food. Planning the basin into the counter or back bar from the start is far easier than squeezing it in after an inspection.
Talk to your local environmental health team early if you are unsure what they will expect. If you are converting a building to café use, planning permission may also be needed depending on its current use, so check with the council's planning department.
Mistakes that cost cafés money
The most expensive errors are usually made on paper, before any timber is cut. Counters built too low force baristas to stoop all day, while counters built too high hide the espresso machine and the barista from customers, losing some of the theatre that sells coffee. A working height of around 900 mm with a customer-facing top raised slightly higher is a common compromise.
Another frequent problem is putting the espresso machine where the water and drain cannot easily reach, leading to long pipe runs and pumped drainage. Fridges squeezed into counters without ventilation gaps run hot, waste energy and fail early. Finally, too little storage under the counter pushes stock onto worktops, which looks untidy and slows service. Thinking through a day's trading with your barista before signing off drawings avoids most of these issues.
- Counter height wrong for staff or customers
- Machine positioned far from water and drainage
- Fridges without proper ventilation gaps
- Too little under-counter storage
- No space reserved for a handwash basin
Timescales and fitting
Most counters are partly built in a workshop and installed over a few days, which reduces disruption on site. A typical sequence is survey, drawings, first fix of water, drainage and electrics, counter installation, templating for stone or quartz tops, top fitting, then second fix and equipment connection. Allow time between templating and fitting for stone tops. Shopfitting is usually done after floors and decoration are close to finished. We arrange café counters through vetted joiners, plumbers and electricians, with one price covering the build and services.
Questions people also ask
How long does it take to build a café counter?
A small counter can be installed in two to four days on site once it is built. A full counter and back bar with sinks, drainage and electrics may take a week or more, plus workshop time beforehand and a gap for stone worktop templating. Planning services early keeps the schedule tight.
Does a café need a separate handwash sink?
In practice, yes. Food hygiene rules require adequate handwashing facilities in food preparation areas, and environmental health officers generally expect a dedicated handwash basin with hot and cold water, separate from equipment and food sinks. Plan it into the counter or back bar design from the start.
Can an existing café counter be refurbished?
Often. If the frame is sound and the services are in sensible positions, the front can be reclad and the top replaced for much less than a new build. Refurbishment is also quicker, which matters when the café is closed for the work. A survey shows whether the structure is worth keeping.
Written and checked by the Coffee Bar Builders team. Read our editorial policy.
More guides
How Much Does a Coffee Bar Cost to Build in the UK?
A simple alcove coffee nook with a base cabinet, worktop, shelves and lighting costs £650–£1,500. A tall larder-style coffee station with pocket…
How to Plumb In a Coffee Machine at Home: What's Involved
Plumbing in a coffee machine means running a cold mains feed with an isolating valve and a water filter to the machine, fitting backflow protection…
Home Coffee Station Planning Checklist: Space, Power and Storage
Before building a home coffee station, measure your machine and grinder with the lids and portafilter in place, allow at least 600 mm of worktop…
Built-In vs Freestanding Coffee Machine: Which Suits Your Kitchen?
A built-in coffee machine sits flush in a tall housing beside ovens, keeping worktops clear, and building or adapting the housing costs £350–£900,…
Get a free coffee bar builders quote
Tell us what you need and we'll come back with a clear price.
Request a quote